Documentation Vision Audit+ Documentation

Vision Audit+ / Administration Guide

Turning features on and off

This chapter switches the four Vision Audit+ features on and off.

Overview

This chapter switches the four Vision Audit+ features on and off.

FeatureDefaultWhat it adds
Display Historyonthe Display History pane, change tracking, revert, recycle bin and snapshots
Display Validationoffthe Display Validation pane and the Draft, In Review, Validated and Archived states
Data Sourcesoffthe Data Sources and Display Usage panes, the data source index and the display health check
Data exportoffdownloading data source values from the Data Sources and Display Usage panes; needs Data Sources

The switches are set in the Configuration Utility because they change both the server and the toolbar. The toolbar only shows the panes whose switch is on in its configuration file vap-config.js.

  1. Run the Configuration Utility and go to the page of the feature: Displays for Display History, Data Sources and data export, Display Validation for validation.
  2. Turn the feature on or off.
  3. On the PI Vision Toolbar page, select Install. This writes the new switches to the toolbar configuration.
  4. Select Apply on the Apply Configuration page.
  5. Ask users to refresh PI Vision.

A switched-off feature does no work on the server. Switching Data Sources off stops the indexing and the health checks and clears the search index; switching it on again rebuilds the index.

If the server and the toolbar disagree, the panes say This feature is disabled on the Vision Audit+ server. Update the toolbar through the Configuration Utility and refresh PI Vision. or The toolbar and server feature settings do not match. Run steps 3 to 5 again. The Configuration view shows the switches read-only, with Toolbar update required when they disagree.