Documentation Vision Audit+ Documentation

Vision Audit+ / User Guide

Display Usage

This chapter finds every display that uses a PI Point or AF attribute, for example before you rename or delete it.

Overview

This chapter finds every display that uses a PI Point or AF attribute, for example before you rename or delete it.

Display Usage with search results

Search for a data source

  1. Open the Display Usage pane.
  2. Type part of the name in Search PI Points or AF attributes... (2 to 200 characters). To narrow the search, select PI Point or AF attribute instead of All kinds.
  3. Select Search or press Enter.

The list shows the matching data sources with the number of displays and symbols that use each of them. More than 100 matches show as (100+); refine the search to see them all. The search covers only displays you are allowed to see.

See where a data source is used

  1. Select a data source in the results.
  2. Optionally filter by origin (Direct, Asset relative, Asset collection) or by symbol type, and select Search.
  3. Select a display to open it.
Displays that use the selected data source

The display opens in the same browser tab, and the symbols that use the data source are outlined until your next click. Select the back arrow to return to the results.

The origin tells how the display reaches the data source:

OriginMeaning
Directthe symbol uses the PI Point or attribute itself
Asset relativethe symbol uses the attribute of the display's asset; the display shows it when this asset is selected in the asset menu
Asset collectionthe symbol uses the attribute on several assets, for example in an asset comparison table

You can also start from the Data Sources pane: open the menu of a data source (three dots) and select Where used.

Note: Display Usage works from an index that the service updates when a display changes. A display saved a moment ago can take a few minutes to appear. If the service does not answer within 2 minutes, the search stops with a message.